Wilbur-curtis TLP61 Manual do Utilizador

Installation Instructions,Service & Warranty InformationWILBUR CURTIS COMPANY Montebello, CA 90640DRAFT COPYNot Released. This Version Exists as

PREVENTIVE MAINTENANCE OF TLP1. Remove the sprayhead from brewer and clean it once a week; more often in heavy limeareas.2. Inside of the heating tank

1/31/00 9.1 I:Diagrams\Fx-134.p65.p1211ELECTRICAL SCHEMATICBrewer Model TLP10 & TLP12

ELECTRICAL SCHEMATIC12Brewer Model TLP15 & TLP17

ELECTRICAL SCHEMATIC13Brewer Model TLP20 & TLP22

14ELECTRICAL SCHEMATICBrewer Model TLP30 & TLP32

15ELECTRICAL SCHEMATICBrewer Model TLP61 & TLP63

8APARTSDIAGRAMSA16257361171391016111512

144BPARTSDIAGRAMSB1724202123181922

PARTS LIST GENERAL PARTS18ITEM ITEM ITEM ITEM ITEM NNNNNºººººPART PART PART PART PART NNNNNºººººDESCRIPTIONDESCRIPTIONDESCRIPTIONDESCRIPTIONDESCRIP

WARRANTY We hereby certify that the products manufactured by the Wilbur Curtis Company, Inc., are, to thebest of our knowledge, free from all defects

Important Safeguards / Conventions . . . . . . . . . . . . . . . . . . . . . . . .Contents & Unpacking . . . . . . . . . . . . . . . . . . . . . .

Printed in U.S.A. 8/03 F-3206 rev CWILBUR CURTIS CO., INC.6913 Acco St., Montebello, CA 90640-5403 U.S.A.Phone: 800/421-6150 (M-F 5:30A - 4:00

UNPACKINGAll products manufactured by the Wilbur Curtis Company arethoroughly inspected at the factory and are warranted to befree of all defects and

QUICK START& SET-UPYour Curtis ADS System is Factory Pre-Set and Ready to Go...Right from the Carton.Following are the Factory Settings for the TL

1. Brewer should be ON (Confirm rear toggle switch is on, then press ON/OFF button).2. Place an empty airpot in position, under the sprayhead.3. Place

READY TO BREWIndicator Light (Red)READY TO BREWFULLBREWHALFBREWI/OON/OFFHOTWATER~~~HOT WATER DispenseButton (Orange)ON/OFF Button(Yellow)FULL BREWBut

Brew Volume - Factory Pre-set Full Brew to 2.2 LitersThe Half Brew button is always half of the brewtime of the setting of the Full Brewbutton. You

Low Temperature Brew Lockout (Delta) - Factory Preset toDelta 1DELTA 1 (this is factory setting) allows you to brew within 5 degrees from set tempera-

9Error Codes are reset by turning the rear toggle switch to Standby for a minimum of 10 seconds, then returningthe switch to ON. Any service required